1. Compulsory Courses FE/ENG1 Introduction to Engineering Part I – Engineering Orientation Part II – Engineering and Scientific Parameters Part III – Engineering Standards and Codes Part IV - Introduction to Engineering Design BUS/COM2 Engineering Communication (iii) Management (iv) Administration FS/CBR2 Applied Science Part I – Physics I Part II – Physics II FC/CBR1 Chemistry CBR5A Mathematics I Part I – College Algebra Part II – Differential Calculus I Part II – Integral Calculus I Part IV – Integral Calculus II CBR5B Mathematics II Part V – College Algebra II Part VI – Vector Analysis and Differential Equations CBR6 Mechanics (v) Statics (vi) Dynamics CCT/CIT01 Engineering Drafting and Design (vii) Drawing I (viii) Drawing II (ix) Drawing III CCT/CIT02 Engineering Materials (civil) CCT01 Concrete Constituent Materials CCT/CNT04 Structural Mechanics CCT/CIT17 Theory of Structures CCT/CIT07 Structural Reliability Analysis CCT/CIT03 Concrete Testing and Quality CCT/CIT18 Reinforced Concrete Design CCT/CNT14 Computers in Engineering (v) Basic Programming Principles (vi) Programming in C++ 2. Optional Course Section 1: Select any four courses from - CCT02 Pre-stressed Concrete CCT03 Formwork for Concrete CCT04 Concrete Processes CCT05 Fracture Mechanics CCT06 Concrete Properties CCT07 Structural Concrete CCT08 Steel, Concrete and Composite Design 3. Optional Course Section 2: Select any two courses from – CCT/CNT12 Construction Project Management CCT/CNT17 Construction Planning CCT/CNT07 Construction Contracting CCT/CNT11 Construction Safety Course Completion: thesis/project Award: DTMS - International Advanced Diploma in Undergraduate Studies in Concrete Technology. Membership: Eligible for membership at the grade of Associate Member (AMDTechMS) within the Technological Chapter. Admission within the International Institute of Engineers (IIE) at the grade of Member (MIIEng). Certification: Registered Concretologist (R Conc)